|
|
本帖最后由 hlhchina 于 2011-11-30 21:38 編輯 * S' h a6 K+ M' k) C3 G0 m( O$ q
' c L; A7 N* V0 n
我在做金屬切削仿真，在金屬切削仿真中采用自適應網格，但是在網格檢查時出現自適應不能使用單元畸變控制！！！5 v- g) h9 h# U4 u, K* C
問題描述如下：' s7 m( k/ g- h$ ]
Adaptive meshing is not supported for elements used with the distortion control. % j% T, Q8 ~. d6 d
Domain name: assembly_adapt
) X2 C: s ~' U+ Q- D" P) VAbaqus/Explicit Packager exited with an error - Please see the status file for possible error messages if the file exists.1 _+ b: }+ X" @/ d0 K7 q" m
/ a! `2 {- j" {. F- O; v! G- v! F9 N
但是不用網格畸變控制吧，又出現了網格畸變問題：( Z; X. t8 O9 u& ?
The elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively." S0 i A# d! q* M
The elements in element set ErrElemZeroALEMass-Step1 have zero or negative mass.
; k/ g! Q! v$ C0 H9 J* G: E! lPrint-out suppressed for subsequent distorted elements, \& ?$ ~/ T6 I/ n* s, n. B
There are a total of 60 excessively distorted elements., j3 V' P$ z; y4 h8 T/ d
請求各位達人幫助，萬分感謝！！！
1 v) i% G* P7 G |
|
發表于 2011-11-30 20:51:21
QQ好友和群
QQ空間
