|
|
本帖最后由 hlhchina 于 2011-11-30 21:38 編輯 $ r5 B7 g# s6 S* J+ Y
# s2 i! ?# q% W4 a/ }7 M我在做金屬切削仿真，在金屬切削仿真中采用自適應網格，但是在網格檢查時出現自適應不能使用單元畸變控制！！！* ~" [$ A' @ i
問題描述如下： z. v5 f; C% _; @+ Y" x0 T
Adaptive meshing is not supported for elements used with the distortion control.
" i" C+ b8 q0 j& k" ]/ `Domain name: assembly_adapt, k+ Y+ A3 |: N' \
Abaqus/Explicit Packager exited with an error - Please see the status file for possible error messages if the file exists.2 T' z8 F* n. J( m& ~; d/ R
" I' c4 d) ?7 s9 A
但是不用網格畸變控制吧，又出現了網格畸變問題：$ e" q8 v# y! h. C
The elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.
4 z3 g! s" O! o# Z4 ^The elements in element set ErrElemZeroALEMass-Step1 have zero or negative mass.7 d- {, @4 {5 ]2 [/ ~9 `
Print-out suppressed for subsequent distorted elements3 K: X' ~3 S% a- @ _; n
There are a total of 60 excessively distorted elements.7 n3 x9 u _9 b3 s/ m B" M
請求各位達人幫助，萬分感謝！！！
- w: R, X. f! C1 w |
|
發表于 2011-11-30 20:51:21
QQ好友和群
QQ空間
